SBus
Four SBus connectors (top of photograph) | |
Year created | 1989 |
---|---|
Created by | Sun Microsystems |
Superseded by | PCI (1997) |
Width in bits | 32 |
Number of devices | 8 masters, unlimited slaves |
Speed | 16.67 MHz - 25 MHz |
Style | Parallel |
SBus is a computer bus system that was used in most SPARC-based computers (including all SPARCstations) from Sun Microsystems and others during the 1990s. It was introduced by Sun in 1989 to be a high-speed bus counterpart to their high-speed SPARC processors, replacing the earlier (and by this time, outdated) VMEbus used in their Motorola 68020- and 68030-based systems and early SPARC boxes. When Sun moved to open the SPARC definition in the early 1990s, SBus was likewise standardized and became IEEE-1496. In 1997 Sun started to migrate away from SBus to the Peripheral Component Interconnect (PCI) bus, and today SBus is no longer used.[1]
The industry's first third-party SBus cards were announced in 1989 by Antares Microsystems; these were a 10BASE2 Ethernet controller, a SCSI-SNS host adapter, a parallel port, and an 8-channel serial controller.
The specification was published by Edward H. Frank and James D. Lyle.[1] A technical guide to the bus was published in 1992 in book form by Lyle,[2] who founded Troubador Technologies. Sun also published a set of books as a "developer's kit" to encourage third-party products.[3]
At the peak of the market over 250 manufacturers were listed in the SBus Product Directory, which was renamed to the SPARC Product Directory in 1996.
SBus is in many ways a "clean" design. It was targeted only to be used with SPARC processors, so most cross-platform issues were not a consideration. SBus is based on a big-endian 32-bit address and data bus, can run at speeds ranging from 16.67 MHz to 25 MHz, and is capable of transferring up to 100 MB/s. Devices are each mapped onto a 28-bit address space (256 MB). Only eight masters are supported, although there can be an unlimited number of slaves.
When the 64-bit UltraSPARC was introduced, SBus was modified to use clock doubling and transfer two 32-bit data words per cycle to produce a 200 MB/s 64-bit bus. This variant of the SBus architecture used the same 96-pin connector as the older one.
SBus cards had a very compact form factor for the time. A single-width card was 3 inches (76 mm) wide by 5 inches (130 mm) long and is designed to be mounted parallel to the motherboard. This allowed for three expansion slots in the slim "pizza box" enclosure of the SPARCstation 1.[4] The design also allows for double- or triple-width cards that take up two or three slots, as well as double-height (two 3x5 inch boards mounted in a "sandwich" configuration) cards.
SBus was originally announced as both a system bus and a peripheral interconnect that allowed input and output devices relatively low latency access to memory.[5] However, soon memory and central processing unit (CPU) speeds outpaced I/O performance. Within a year some Sun systems used MBus, another interconnection standard, as a CPU—memory bus. The SBus served as an input/output bus for the rest of its lifetime.
See also
References
- 1 2 "PCI:SBus Comparison" (PDF). Sun Microsystems. March 1999. Retrieved May 25, 2011.
- ↑ James D. Lyle (1992). SBus Information Applications and Experience. Springer-Verlag. ISBN 978-0-387-97862-8.
- ↑ Susan A. Mason (1994). SBus handbook. Sun Microsystems. ISBN 978-0-13-107210-7.
- ↑ Andy Bechtolscheim; Edward H. Frank (February 26, 1990). "Sun's SPARCstation 1: a workstation for the 1990s". Compcon Spring '90: Intellectual Leverage. Thirty-Fifth IEEE Computer Society International Conference: 184–188. doi:10.1109/CMPCON.1990.63671.
- ↑ Edward H. Frank (February 26, 1990). "The SBus: Sun's high performance system bus for RISC workstations". Compcon Spring '90: Intellectual Leverage. Thirty-Fifth IEEE Computer Society International Conference: 189–194. doi:10.1109/CMPCON.1990.63672.