Radiometric calibration
Radiometric calibration is a general term used in science and technology for any set of calibration techniques in support of the measurement of electromagnetic radiation and atomic particle radiation. These can be for instance, in the field of Radiometry or the measurement of ionising radiation radiated from a source.
Ionising radiation
Ionising radiation is non-visible and requires the use of ionisation detectors such as the Geiger Muller counter or ion chamber for its detection and measurement. Instruments are calibrated using standards traceable to national laboratory radiation standards, such as those at The National Physical Laboratory in the UK.
Count rate measurements are normally associated with the detection of particles, such as alpha particles and beta particles. However, for gamma ray and X-ray dose measurements a unit such as the gray or sievert is normally used.
The following table shows ionising radiation quantities in SI and non-SI units.
| Quantity | Name | Symbol | Unit | Year | System |
|---|---|---|---|---|---|
| Exposure (X) | röntgen | R | esu / 0.001293 g of air | 1928 | non-SI |
| Absorbed dose (D) | erg•g−1 | 1950 | non-SI | ||
| rad | rad | 100 erg•g−1 | 1953 | non-SI | |
| gray | Gy | J•kg−1 | 1974 | SI | |
| Activity (A) | curie | Ci | 3.7 × 1010 s−1 | 1953 | non-SI |
| becquerel | Bq | s−1 | 1974 | SI | |
| Dose equivalent (H) | röntgen equivalent man | rem | 100 erg•g−1 | 1971 | non-SI |
| sievert | Sv | J•kg−1 | 1977 | SI | |
| Fluence (Φ) | (reciprocal area) | cm−2 or m−2 | 1962 | SI (m−2) |
Satellite sensor calibration
Spectral data acquired by satellite sensors are influenced by a number of factors, such as atmospheric absorption and scattering, sensor-target-illumination geometry, sensor calibration, and image data processing procedures, which tend to change through times (Teillet, 1986). Targets in multi-date scenes are extremely variable and have been nearly impossible to compare in an automated mode (Kim and Elman, 1990). In order to detect genuine landscape changes as revealed by changes in surface reflectance from multi-date satellite images, it is necessary to carry out radiometric correction. Two approaches to radiometric correction are possible: absolute and relative (Lo and Yang, 1998). The absolute approach requires the use of ground measurements at the time of data acquisition for atmospheric correction and sensor calibration. This is not only costly but also impractical when archival satellite image data are used for change analysis (Hall et al., 1991). The relative approach to radiometric correction, known as relative radiometric normalization (RRN), ispreferred because no in situ atmospheric data at the time of satellite overpasses are required. This method involves normalizing or rectifying the intensities or digital numbers (DN) of multi-date images bandby-band to a reference image selected by the analyst. The normalized images would appear as if they were acquired with the same sensor under similar atmospheric and illumination conditions to those of the reference image.[1]
References
- ↑ Yang, Xiajun, and C. P. Lo. "Relative radiometric normalization performance for change detection from multi-date satellite images." Photogrammetric Engineering and Remote Sensing 66.8 (2000): 967-980.
- Olsen, Doug; Dou, Changyong; Zhang, Xiaodong; Hu, Lianbo; Kim Hojin; Hildum, Edward. 2010. "Radiometric Calibration for AgCam" Remote Sens. 2, no. 2: 464-477.
- Yang, Xiajun, and C. P. Lo. "Relative radiometric normalization performance for change detection from multi-date satellite images." Photogrammetric Engineering and Remote Sensing 66.8 (2000): 967-980.