Nernst lamp

Nernst lamp, complete, model B with cloche, DC-lamp 0.5 ampere, 95 volts, by courtesy of Landesmuseum für Technik und Arbeit in Mannheim, Germany, (Engl.: State Museum of Technology and Labour, Mannheim)
A Nernst lamp diagram from 1903. The light-emitting ceramic filament is called a "glower"

The Nernst lamp was an early form of incandescent lamp. Nernst lamps did not use a glowing tungsten filament. Instead, they used a ceramic rod that was heated to incandescence. Because the rod (unlike tungsten wire) would not further oxidize when exposed to air, there was no need to enclose it within a vacuum or noble gas environment; the burners in Nernst lamps could operate exposed to the air and were only enclosed in glass to isolate the hot incandescent emitter from its environment. A ceramic of zirconium oxide - yttrium oxide was used as the glowing rod.[1]

Developed by the German physicist and chemist Walther Nernst in 1897 at Goettingen University, these lamps were about twice as efficient as carbon filament lamps and they emitted a more "natural" light (more similar in spectrum to daylight). The lamps were quite successfully marketed for a time, although they eventually lost out to the more-efficient tungsten filament incandescent light bulb. One disadvantage of the Nernst design was that the ceramic rod was not electrically conductive at room temperature so the lamps needed a separate heater filament to heat the ceramic hot enough to begin conducting electricity on its own.

In the U.S., Nernst sold the patent to George Westinghouse who founded the Nernst Lamp Company at Pittsburgh in 1901. Minerals for the production of the glowers were extracted from the company's own mines at the legendary Barringer Hill, Texas (since 1937 submerged beneath the waters of Lake Buchanan). By 1904 a total of over 130,000 Nernst lamps had been placed in service throughout the country.

In Europe, the lamps were produced by the German Allgemeine Elektrizitäts-Gesellschaft (AEG, General Electricity Company) at Berlin. At the 1900 World's Fair held in Paris the pavilion of the AEG was illuminated by 800 Nernst lamps which was quite spectacular at that time.

In addition to their usage for ordinary electric illumination, Nernst lamps were used in one of the first practical long-distance photoelectric facsimile (fax) systems, designed by professor Arthur Korn in 1902, in Allvar Gullstrand's slit lamp (1911) for ophthalmology, for projection and in microscopy.

After Nernst lamps fell into obsolescence "Nernst glowers" went on to be used as the infrared-emitting source used in IR spectroscopy devices. (Recently, even this has become obsolete as Nernst glowers have been largely replaced for this purpose by silicon carbide glow bars or "globars",[2] which are conductive even at room temperature and therefore need no preheating.)

See also

References

  1. ↑ Allan Mills, "The Nernst Lamp. Electrical Conductivity in Non-Metallic Materials". eRittenhouse, Vol.24, No. 1, June 2013. (Text on line)
  2. ↑ "Kanthal Globar Heating Elements". Applied Thermal Systems. Retrieved 17 June 2013.
Wikimedia Commons has media related to Nernst lamps.
This article is issued from Wikipedia - version of the 11/1/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.