Mac OS nanokernel

The Mac OS nanokernel is an extremely simple operating system kernel serving as the basis of most PowerPC based system software versions 7 through 9 of the classic Mac OS, predating Mac OS X.

The initial revision of this software is an extremely simple, single tasking system which delegates most tasks to an emulator running the Motorola 68K version of the operating system. The second major revision supports multitasking, multiprocessing, and message passing, and would be more properly called a microkernel. Unlike the 68K-derived Mac OS kernel running within it, the PowerPC kernel exists in a protected memory space and executes device drivers in user mode.

The nanokernel is completely different from the Copland OS microkernel, although they were created in succession with similar goals.[1][2][3]

System 7.1.2—Mac OS 8.5.1

The original nanokernel, and the tightly integrated Mac 68k emulator, were written by emulation consultant Gary Davidian.[4] Its main purpose is to allow the existing Motorola 68K version of the operating system to run on new hardware. As such, the normal state of the system is to be running 68K code. The operating system does little until activated by an interrupt, which is quickly mapped to its 68K equivalent within the virtual machine.

Other tasks may include switching back to PowerPC mode, if necessary, upon completion of the interrupt handler, and mapping the Macintosh virtual memory system to the PowerPC hardware. However, as the software is little documented, these might instead be handled by the emulator running in user mode.

This nanokernel is stored on the Mac OS ROM chip integrated into Old World ROM computers, or inside the Mac OS ROM file on disk on the New World ROM computers, rather than being installed in the familiar sense.

Interim development

Progress after 1994 demanded additional functionality. A forward-looking architecture was introduced for PCI card drivers in anticipation of Copland OS, which supported memory protection. The Open Transport networking architecture introduced standardized PowerPC synchronization primitives. The DayStar Digital Genesis MP Macintosh clone requires kernel extensions to support multiprocessing. This evolution would later affect the overhaul to the nanokernel in Mac OS 8.6.

Mac OS 8.6 and later

Mac OS 8.6's nanokernel was rewritten by René A. Vega to add Multiprocessing Services 2.0 support. PowerMacInfo (distributed in the Multiprocessing SDK) is an application that displays statistics about the nanokernel's operation.[5]

References

  1. ↑ Inside Macintosh: PowerPC System Software. Apple Technical Library. Reading, Mass.: Addison-Wesley Pub. Co. 1994. ISBN 978-0-201-40727-3. OCLC 29636881. Retrieved April 3, 2013.
  2. ↑ Inside Macintosh: PowerPC System Software. Apple Technical Library. Apple Computer, Inc. July 3, 1996. Archived from the original on May 18, 2008. Retrieved April 4, 2013.
  3. ↑ "Technical Note TN1084: Running CFM-68K Code at Interrupt Time: Is Your Code at Risk?". Apple Computer, Inc. March 27, 1997. Archived from the original on June 23, 2004. Retrieved April 4, 2013.
  4. ↑ "The Road to Power Macintosh". 11. Macworld. May 1994.
  5. ↑ René A. Vega (October 25, 2001). "PowerMacInfo info". Newsgroup: comp.sys.mac.programmer.help. Retrieved May 12, 2016.

External links

This article is issued from Wikipedia - version of the 9/25/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.