Iron Fist (countermeasure)

Iron Fist APS

Iron Fist (Hebrew: חץ דורבן‎‎, Hetz Dorban, lit. Porcupine Arrow) is a hard-kill active protection system (APS) designed by Israel Military Industries (IMI), with a modular design allowing adaptation to a range of platforms ranging from light utility vehicles to heavy armoured fighting vehicles. The concept was revealed by IMI in 2006 and was expected to enter Israel Defense Forces tests by mid-2007. The system has been successfully tested against a wide variety of threats including rocket-propelled grenades, anti-tank guided missiles and tank-fired HEAT ammunition and kinetic energy penetrators.

It senses incoming threats via a fixed radar sensor developed by RADA Electronic Industries and an optional passive infrared detector developed by Elbit's Elisra. When a threat is imminent, an explosive projectile interceptor is launched towards it. The interceptor explodes very near the threat, destroying or deflecting and destabilizing it without detonating its warhead. For this, only the blast effect of the explosive is used. The interceptor casing is made of combustible materials so no fragmentation is formed in the explosion, helping minimize collateral damage.

Acquisition of the Iron Fist active protection system was approved in June 2009. The system was to be installed on the Namer armoured personnel carrier.[1]

In November 2010, The Israeli ministry of defense announced the stop of funding of the system development.[2][3]

In May 2011, the system intercepted Kinetic energy penetrators and Metis anti tank missiles during a test in the U.S.[4]

In early 2013, the MoD tested both the IMI Iron Fist and Rafael Advanced Defense Systems Trophy in a competition to select a single second-generation APS for IDF vehicles. Both systems were first-generation standard at the time. Both systems were financed concurrently until 2010, when the ministry's participation in funding the Iron Fist was suspended and limited procurement of the Trophy was initiated. In 2012, the ministry attempted to combine the two systems into one, utilizing the Iron Fist's interceptor and the Trophy's Elta radar and C3 system. Because Rafael would serve as the prime contractor instead of both companies being equal partners, IMI refused to cooperate. After 2013 trials, completion of a second-generation APS would be completed within a few years. IMI is also trying to market the Iron Fist internationally.[5]

In December 2014, it was revealed that Rafael, Israel Aerospace Industries, and IMI had agreed to jointly develop a next-generation active defense system for vehicles, based on a combination of the Rafael/IAI Trophy and IMI Iron Fist. Rafael will act as the main contractor and system developer and integrator, and IAI and IMI will be subcontractors providing the radar and interceptor respectively. Unlike the Trophy's interception method of metal pellets that spread over a wide area, IMI's interceptor is based on an anti-missile missile. Interest for a vehicle APS grew significantly following Trophy's successful performance during Operation Protective Edge in mid-2014, where tanks equipped with the system intercepted dozens of ATGMs and RPGs, and suffered no injuries or false alarms. The Defense Ministry had pushed the companies to work together and combine their systems.[6]

In June 2016, the U.S. Army chose the Iron Fist Light configuration to protect its light and medium armored vehicles as part of the Modular Active Protection System (MAPS) program. The decision to select Iron Fist was made because of the system’s light weight, ability to fire interceptors without shock, and low cost.[7][8]

References


This article is issued from Wikipedia - version of the 11/17/2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.