High endurance cutter
_underway.JPG)
The designation of High endurance cutter (WHEC) was created in 1965 when the United States Coast Guard adopted its own designation system. High endurance cutters encompass the largest cutters previously designated by the United States Navy as gunboats, destroyer escorts, and seaplane tenders.[1] The term High Endurance Cutter may refer to any of four individual ship classes that have seen service in the Coast Guard.
- The National Security Cutter also known as the Legend class is the newest, and largest cutter class.
- The Hamilton-class cutter is a contemporary design. These vessels are also known as Secretary- or Hero-class cutters. They are currently being replaced by newer National Security Cutters.
- The Owasco-class cutter was a World War II design, the last was retired in the 1970s.
- The Casco-class cutter was a pre-World War II design, the last was retired in the 1980s under the Philippine Navy.
- The Treasury-class cutter, a 327-foot (100 m) class from 1936 to the mid-1980s.
Class history
_off_Vietnam_in_1968.jpg)
The US Coast Guard's predecessor, the US Revenue Cutter Service designated cutters and craft based on classes. From approximately 1890 through to the formation of the US Coast Guard in 1915, the largest cutters were considered "First" class, coastal cutters and large tugs "Second" class, and small tugs and cutters "Third" class. Small harbor craft and similar vessels were referred to as "Launches".
With the formation of the US Coast Guard in 1915 classes were replaced by names. First class vessels became Cruising Cutters, while second and third class vessels became Harbor Cutters. This was further divided in 1920 when former second class ships were designated Inshore Patrol Cutters. Small craft continued to be referred to as Launches.
Starting during Prohibition as part of the US Coast Guard's response to liquor smuggling, the service commissioned a number of ex-US Navy destroyers to enhance the fleet. These vessels were classified as Coast Guard Destroyers until 1942 when the Coast Guard adopted Navy-style ship classifications. To distinguish US Navy ships from Coast Guard ships, the prefix letter "W" was affixed in front of all Coast Guard ship classifications. "W" was selected as it was unused in the Navy, and was thus free to be assigned without changing or confusing existing classifications.
Following the conclusion of World War II, the Coast Guard was transferred back to control of the US Treasury Department, but retained the ship classification system.
In 1965 the Coast Guard began classifying all large cutters as High Endurance Cutters (WHEC).
References
- US Department of Homeland Security. United States Coast Guard Historian's Office
- US Department of Homeland Security. United States Coast Guard Historian's Office